Cisco Nexus 7000 Series Configuration Manual page 123

Configuring PIM and PIM6
Message Type
Auto-RP candidate RP policy
Auto-RP mapping agent policy
Per Device Interface
Join-prune policy
4
For information about configuring route-map policies, see the Cisco Nexus 7000 Series NX-OS Unicast
Routing Configuration Guide.
Route maps as a filtering policy can be used (either permit or deny for each statement) for the following
commands:
• jp-policy can use (S,G), (*,G), or (RP,G)
• register-policy can use (S,G) or (*,G)
• igmp report-policy can use (*,G) or (S,G)
• state-limit reserver-policy can use (*,G) or (S,G)
• auto-rp rp-candidate-policy can use (RP,G)
• bsr rp-candidate-policy can use (group-range/G, RP, RP-type)
• autorp mapping-agent policy can use (S)
• bsr bsr-policy can use (S)
Description
Enables Auto-RP announce messages to be filtered
by the Auto-RP mapping agents based on a route-map
policy1 where you can specify the RP and group
addresses, and whether the type is Bidir or ASM with
the match ip multicast command. This command
can be used on a mapping agent. The default is no
filtering of Auto-RP messages.
Note
Enables Auto-RP discover messages to be filtered by
client routers based on a route-map policy1 where
you can specify mapping agent source addresses with
the match ip multicast command. This command
can be used on client routers that listen to discover
messages. The default is no filtering of Auto-RP
messages.
Note
Enables join-prune messages to be filtered based on
a route-map policy1 where you can specify group,
group and source, or group and RP addresses with the
match ip[v6] multicast command. The default is no
filtering of join-prune messages.
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Configuring Message Filtering
PIM6 does not support the Auto-RP
method.
PIM6 does not support the Auto-RP
method.
109