Configuring Msdp Peer Parameters - Cisco Nexus 7000 Series Configuration Manual

Configuring MSDP
Step 5

Configuring MSDP Peer Parameters

You can configure the optional MSDP peer parameters described in this table. You configure these parameters
in global configuration mode for each peer based on its IP address.
Table 20: MSDP Peer Parameters
Parameter
Description
Administrative shutdown
MD5 password
SA policy IN
SA policy OUT
SA limit
5
6
Note
Only the match ip multicast group command is supported for MSDP SA policy. The match ip address
command for matching an ACL is not supported.
Command or Action
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
To configure route-map policies, see the Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration
Guide.
To configure route-map policies, see the Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration
Guide.
Purpose
(Optional) Saves configuration changes.
Description
Description string for the peer. By default, the peer
has no description.
Method to shut down the MSDP peer. The
configuration settings are not affected by this
command. You can use this parameter to allow
configuration of multiple parameters to occur before
making the peer active. The TCP connection with
other peers is terminated by the shutdown. By default,
a peer is enabled when it is defined.
MD5-shared password key used for authenticating
the peer. By default, no MD5 password is enabled.
Route-map policy
default, all SA messages are received.
Route-map policy
default, all registered sources are sent in SA messages.
Number of (S, G) entries accepted from the peer and
stored in the SA cache. By default, there is no limit.
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Configuring MSDP Peer Parameters
5
for incoming SA messages. By
6
for outgoing SA messages. By
163