Cisco Nexus 7000 Series Configuration Manual page 153

Configuring IGMP Snooping
Parameter
Version
Note Beginning with Cisco Release 5.1(1), step 3 in the following procedure changed from vlan to vlan
configuration vlan-id. You configure the IP IGMP snooping parameters that you want by using this
configuration mode; however, the configurations apply only after you specifically create the specified VLAN.
See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide for information on creating
VLANs.
Procedure
Step 1
Step 2
Step 3
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
ip igmp snooping
Example:
switch(config)# ip igmp snooping
Option
vlan
vlan-id
switch(config)# vlan 2
switch(config-vlan)#
vlan
configuration
vlan-id
switch(config)# vlan
configuration 2
switch(config-vlan-config)#
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Configuring IGMP Snooping Parameters per VLAN
Description
Configures the IGMP version number for the specified
VLANs.
You must configure access-group (policy
Note
filter), for this command to function
correctly.
Purpose
Enters global configuration mode.
Enables IGMP snooping for the current VDC.
The default is enabled.
Note If the global setting is disabled with
the no form of this command, IGMP
snooping on all VLANs is disabled,
whether IGMP snooping is enabled
on a VLAN or not. If you disable
IGMP snooping, Layer 2 multicast
frames flood to all modules.
Depending on your release of Cisco NX-OS,
Description
use one of the commands in the table.
Enters
VLAN
configuration
mode.
Beginning
with Cisco
Release
5.1(1), use
this
command to
configure the
139