Cisco Nexus 7000 Series Configuration Manual page 61

Configuring MLD
Command or Action
Option
Example
switch(config-if)# ipv6 mld
robustness-variable 3
ipv6 mld querier-timeout
Example
switch(config-if)# ipv6 mld
querier-timeout 300
ipv6 mld query-timeout
Example
switch(config-if)# ipv6 mld
query-timeout 300
ipv6 mld
query-max-response-time
Example
switch(config-if)# ipv6 mld
query-max-response-time 15
ipv6 mld query-interval
Example
switch(config-if)# ipv6 mld
query-interval 100
ipv6 mld
last-member-query-response-time
seconds
Example
switch(config-if)# ipv6 mld
last-member-query-response-time 3
Cisco Nexus 7000 Series NX-OS Multicast Routing Configuration Guide
Configuring MLD Interface Parameters
Purpose
Description
larger value for a lossy
network. Values can range
from 1 to 7. The default is
2.
Sets the querier timeout
seconds
that the software uses
when deciding to take
over as the querier.
Values can range from 1
to 65,535 seconds. The
default is 255 seconds.
Sets the query timeout
seconds
that the software uses
when deciding to take
over as the querier.
Values can range from 1
to 65,535 seconds. The
default is 255 seconds.
This command
Note
has the same
functionality as
the ipv6 mld
querier-timeout
command.
Sets the response time
advertised in MLD
seconds
queries. Values can range
from 1 to 25 seconds. The
default is 10 seconds.
Sets the frequency at
interval
which the software sends
MLD host query
messages. Values can
range from 1 to 18,000
seconds. The default is
125 seconds.
Sets the query interval
waited after sending
membership reports
before the software
deletes the group state.
Values can range from 1
47