Reading Roller (Center) - Canon imageFORMULA DR-X10C Service Manual

5. Reading Roller (Center)

1) Remove the left covers.
(Page 3-5)
2) Remove 2 screws
ing a short screwdriver, lift the front of the
guide plate 2 , and while unhooking 2
pairs of the rear fitting parts
the guide. Unhook 2 pairs of the fitting
parts 4 and remove the gear
6 .
Note: Do not drop and lose the pin.
If a short screwdriver is not available,
remove the upper unit.
Figure 3-409
COPYRIGHT © CANON ELECTRONICS INC. 2008
1 (M3, round tip) us-
3 , remove
5 and pin
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
3) Remove the stop ring
moving the ball bearings
remove the reading roller (center)
Figure 3-410
Notes on assembling
There is only one stop ring at the left side.
Insert the fitting parts of the guide plate
below the fitting parts of the platen roller.
1 , and while re-
2 on both sides,
3 .
3-27