4. Reading Roller (Center)
1) Remove the platen roller.
(Page 3-51)
2) Open the end (marked with
bearing holders
the fitting parts, remove the reading roller
(center) unit
2
.
Note: For other precautions and subsequent
procedures, refer to the "Reading Roller
(Front)" section.
Figure 3-806
COPYRIGHT © CANON ELECTRONICS INC. 2008
) of both
1
, and while unhooking
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
5. Reading Roller (Rear)
1) Remove 2 screws
remove the guide plate
Figure 3-807
2) Insert a tool with a thin and flat tip into a
clearance between the base side plate and
the upper unit, open the end (marked with
) of both bearing holders
unhooking the fitting parts, remove the
reading roller (rear) unit
Note: For other precautions and subsequent
procedures, refer to the "Reading Roller
(Front)" section.
Figure 3-808
1
(M3, round tip) and
2
.
1
, and while
2
.
3-53