Shading Motor - Canon imageFORMULA DR-X10C Service Manual

3. Shading Motor

1) Remove the reading PCB.
(Page 3-33)
Note: When mounting the shading motor, the
reading PCB must be removed.
2) Remove the connector
2 (M3, self-tapping, black) and remove
the shading motor
Figure 3-510
Notes on assembling
1) Move the slide plate
align the position of the groove
holes for the motor.
3
Figure 3-511
COPYRIGHT © CANON ELECTRONICS INC. 2008
1 and 2 screws
3 and cover 4 .
with hand , and
1
with 2
2
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
2) Align the motor rotating shaft
holes 2 for fixing.
Figure 3-512
3) After assembling the cover
rotating shaft into the hole in the cover so
that it does not move, and mount the motor
so that the cover aligns with the motor
fixing holes.
Note: If each position is aligned, the end of the
rotating shaft fits in the groove in the
slide plate.
Figure 3-513
1 with 2
1 , insert the
3-35