Reading Holder; Blower - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

5. Reading Holder

Note: A reading glass and a shading sheet are
mounted in this reading holder. If it is
removed, the CIS unit is exposed.
1) Open the upper unit.
2) Slide the reading holder to the left and
remove it while pushing down the fitting
parts 2 on the rear left side of the reading
holder 1 with a tool with a thin tip.
Figure 3-520
3-38

6. Blower

1) Remove the reading unit.
(Page 3-32)
2) While unhooking the fitting parts
and remove the blower
ting parts
Note: If the fitting parts
Notes on assembling
Insert the blower discharge opening
into the opening in the reading unit. While
aligning 2 pairs of the fitting parts
the blower in.
COPYRIGHT © CANON ELECTRONICS INC. 2008
2 are removed.
1
sively, they may be damaged.
Figure 3-521
Figure 3-522
CANON DR-X10C FIRST EDITION
1 , tilt
3 so that the fit-
are bent exces-
1
2 , push