Eject Pcb; Platen Motor (Lower) - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

13. Eject PCB

1) Remove the eject unit.
(Page 3-21)
2) Remove the cable
(M3, round tip) and remove the eject PCB
3 (with a leaf spring).
Figure 3-324
3) Grasp the head of the rivet
out with a tool, such as nippers. Then,
remove the base of the rivet and remove
the leaf spring
2
Figure 3-325
3-22
1 and 2 screws
and pull it
1
.
COPYRIGHT © CANON ELECTRONICS INC. 2008

14. Platen Motor (Lower)

1) Remove the reading unit (lower).
(Page 3-32)
2 2) Remove 2 screws
the left side plate.
3) Take the motor unit
the cable
1 (M3, round tip) in
Figure 3-326
out and remove
1
.
2
Figure 3-327
CANON DR-X10C FIRST EDITION