Xconfiguration Cameras Preset Triggerautofocus; Xconfiguration Cameras Speakertrack Mode; Xconfiguration Cameras Speakertrack Closeup; Xconfiguration Cameras Speakertrack Trackingmode - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xConfiguration Cameras Preset TriggerAutofocus

The current position (pan and tilt), zoom and focus are stored with a preset. Use this setting to
determine if the camera should refocus or use the focus value that is stored with the preset.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Cameras Preset TriggerAutofocus:
where
: Auto/Off/On
TriggerAutofocus
Auto: Whether the camera refocuses or not when selecting a preset, depends on the
camera type.
Off: The focus value that is stored with the preset will be used. The camera will not
refocus when selecting a preset.
On: The camera will refocus when selecting a preset. The focus value that is stored with
the preset may be overridden.

xConfiguration Cameras SpeakerTrack Mode

This setting applies only when using a Cisco TelePresence SpeakerTrack 60 camera.
The SpeakerTrack 60 camera assembly consists of two cameras and uses an audio tracking
technique that finds and captures a close-up of the active speaker. When a change of speaker
is detected, the system can switch automatically between the two cameras to always show
the best camera view. Refer to the Cameras SpeakerTrack TrackingMode setting for different
switching modes.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras SpeakerTrack Mode:
where
: Auto/Off
Mode
Auto: Speaker tracking is switched on. The cameras in the camera assembly behave
as one integrated unit that finds the active speaker and dynamically chooses the best
camera view.
Off: The cameras operate as two individual cameras. Speaker tracking is not used.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xConfiguration
TriggerAutofocus
Mode
xCommand

xConfiguration Cameras SpeakerTrack Closeup

This setting applies only when the Cameras SpeakerTrack Mode is set to Auto.
When a person in the room speaks the system will find the person and select the best camera
framing. This is called a closeup and may not include all the persons in the room. If you
want all the persons in the room to be in the picture at all times you can turn off the closeup
functionality.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras SpeakerTrack Closeup:
where
: Auto/Off
Closeup
Auto: The system will zoom in on the person speaking.
Off: The system will keep all the persons in the room in the camera framing at all times.

xConfiguration Cameras SpeakerTrack TrackingMode

This setting applies only when using a Cisco TelePresence SpeakerTrack 60 camera, and when
Cameras SpeakerTrack Mode is set to Auto.
The speaker tracking algorithm can react to changes in two modes, one faster than the other.
The mode determines when the camera view will change to a new speaker.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras SpeakerTrack TrackingMode:
where
: Auto/Conservative
TrackingMode
Auto: Normal tracking mode.
Conservative: The camera view will change to a new speaker later than in Normal mode.
46
API Reference Guide
xStatus Appendices
Closeup
TrackingMode
Copyright © 2017 Cisco Systems, Inc. All rights reserved.