Xcommand Call Farendmessage Tstringsend; Xcommand Call Forward; Xcommand Call Hold; Xcommand Call Ignore - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xCommand Call FarEndMessage TStringSend

Send data to far end, e.g. for TelePresence control systems. Uses the H.245 control channel
(TCP). Works with H.323 calls only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call FarEndMessage TStringSend Message: "Message" CallId:
where
: String (0, 255)
Message
Enter the message to be sent to the far end.
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call Forward

Specifies what number or URI you want to forward your incoming calls to. The display name is a
local reference for the forwarded destination. A message, together with the local reference, is
shown on screen when you have configured the system to forward all calls.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Forward DisplayName: "DisplayName" Number: "Number"
where
: String (0, 255)
DisplayName
The local reference for the forwarded destination.
: String (0, 255)
Number
The directory number or URI which you want to forward the incoming calls to.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration xCommand xCommand

xCommand Call Hold

Put a call on hold.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Hold [CallId: CallId] [Reason: Reason]
CallId
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
: Conference/Transfer/Other
Reason
Internal usage only.

xCommand Call Ignore

Turns off the ringtone for the incoming call. The call can still be answered.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Ignore CallId:
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.

xCommand Call Join

Internal usage only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Join CallId:
where
: Integer (0..65534)
CallId
You can have from 1 to 10 CallId parameters in the same command.
116
API Reference Guide
xStatus
CallId
CallId
Copyright © 2017 Cisco Systems, Inc. All rights reserved.
Appendices