Xconfiguration Cameras Camera [1..7] Whitebalance Level; Xconfiguration Cameras Preset Triggerautofocus; Xconfiguration Cameras Speakertrack Mode; Xconfiguration Cameras Speakertrack Trackingmode - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xConfiguration Cameras Camera [1..7] Whitebalance Level

Define the white balance level. Requires the Cameras Camera [n] Whitebalance Mode to be set
to manual.
Requires user role: USER
Default value: 1
USAGE:
xConfiguration Cameras Camera n
where
Level
: Integer (1..16)
The white balance level.

xConfiguration Cameras Preset TriggerAutofocus

The current position (pan and tilt), zoom and focus are stored with a preset. Use this setting to
determine if the camera should refocus or use the focus value that is stored with the preset.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Cameras Preset TriggerAutofocus:
where
TriggerAutofocus
: Auto/Off/On
Auto: Whether the camera refocuses or not when selecting a preset, depends on the
camera type.
Off: The focus value that is stored with the preset will be used. The camera will not
refocus when selecting a preset.
On: The camera will refocus when selecting a preset. The focus value that is stored with
the preset may be overridden.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xConfiguration
Whitebalance Level: Level
TriggerAutofocus
xCommand

xConfiguration Cameras SpeakerTrack Mode

This setting applies only to systems with a dual camera (speaker track).
The dual camera assembly consists of two cameras and uses an audio tracking technique that
finds and captures a close-up of the active speaker. When a change of speaker is detected, the
system can switch automatically between the two cameras to always show the best camera
view. Refer to the Cameras SpeakerTrack TrackingMode setting for different switching modes.
Requires user role: USER
Default value: Auto
USAGE:
xConfiguration Cameras SpeakerTrack Mode:
where
Mode
: Auto/Off
Auto: Speaker tracking is switched on. The cameras in the camera assembly behave
as one integrated unit that finds the active speaker and dynamically chooses the best
camera view.
Off: The cameras operate as two individual cameras. Speaker tracking is not used.

xConfiguration Cameras SpeakerTrack TrackingMode

This setting applies only to systems with a dual camera (speaker tracking), and when Cameras
SpeakerTrack Mode is set to Auto.
The speaker tracking algorithm can react to changes in two modes, one faster than the other.
The mode determines when the camera view will change to a new speaker.
Requires user role: USER
Default value: Auto
USAGE:
xConfiguration Cameras SpeakerTrack TrackingMode:
where
TrackingMode
: Auto/Conservative
Auto: Normal tracking mode.
Conservative: The camera view will change to a new speaker later than in Normal mode.
46
API Reference Guide
xStatus Appendices
Mode
TrackingMode
Copyright © 2016 Cisco Systems, Inc. All rights reserved.