Xcommand Audio Remoteoutput Updateinputgain; Xcommand Audio Setup Clear; Xcommand Audio Sound Play; Xcommand Audio Sound Stop - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80

Introduction

xCommand Audio RemoteOutput UpdateInputGain

Update the gain of an input that is connected to a remote output. Note that the remote output is
automatically removed when the call has ended.
Run xStatus Audio Output RemoteOutput to get an overview of the remote outputs, and xStatus
Audio Input LocalInput to get an overview of all local inputs.
This command is mainly intended for internal use by the CE Console. It is only applicable during
a call.
Requires user role: ADMIN
USAGE:
xCommand Audio RemoteOutput UpdateInputGain OutputId:
[InputGain: InputGain]
where
: Integer (0..65534)
OutputId
The unique identifier of the remote output. It was automatically generated when the call
was made.
: Integer (0..65534)
InputId
The unique identifier of the input. It was either generated when the input was created
with the xCommand Audio Local Input Add command, or when the call was set up
(remote input).
: Integer (-54..15)
InputGain
Set the gain on the input signal. The gain can also be negative (attenuation). The value
-54 dB equals Off.

xCommand Audio Setup Clear

Remove all local inputs and local outputs.
Requires user role: ADMIN
USAGE:
xCommand Audio Setup Clear
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API xConfiguration
OutputId InputId:
xCommand xCommand

xCommand Audio Sound Play

Play a specified audio sound.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio Sound Play [Loop: Loop] Sound:
where
: Off/On
Loop
Determines whether or not to loop the playout of the audio sound. The sound is
looped by default. Irrespective of how this parameter is set, some of the sounds
InputId
(Busy, CallWaiting, Dial, Ringing, and SpecialInfo) will play until the Audio Sound Stop
command is issued.
: Alert/Bump/Busy/CallDisconnect/CallInitiate/CallWaiting/Dial/KeyInput/
Sound
KeyInputDelete/KeyTone/Nav/NavBack/Notification/OK/PresentationConnect/Ringing/SignIn/
SpecialInfo/TelephoneCall/VideoCall/VolumeAdjust/WakeUp
Choose which ringtone to play.

xCommand Audio Sound Stop

Stop playing audio sound.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio Sound Stop

xCommand Audio SoundsAndAlerts Ringtone List

List all available ringtones. Use the xConfiguration Audio SoundsAndAlerts RingTone setting to
choose a ringtone.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio SoundsAndAlerts Ringtone List
110
API Reference Guide
xStatus Appendices
Sound
Copyright © 2017 Cisco Systems, Inc. All rights reserved.