Cisco TelePresence SX80
Introduction
Call commands
xCommand Call Accept
Accept an incoming call. If no CallId is specified, all incoming calls are accepted.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Accept [CallId: CallId]
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
xCommand Call Disconnect
Disconnect a call.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Disconnect [CallId: CallId]
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
Cisco TelePresence SX80 API Reference Guide CE9.1, JUNE 2017.
D15317.07
About the API
xConfiguration
xCommand
xCommand
xCommand Call DTMFSend
Send DTMF tones to the far end.
Requires user role: ADMIN, USER
USAGE:
xCommand Call DTMFSend [CallId: CallId] DTMFString: "DTMFString"
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
: String (0, 32)
DTMFString
Enter the DTMF string.
xCommand Call FarEndControl Camera Move
Move the far end camera (the remote camera).
NOTE: The far end camera moves in the specified direction until the stop command (ref:
xCommand FarEndControl Camera Stop) is issued.
Requires user role: ADMIN, USER
USAGE:
xCommand Call FarEndControl Camera Move [CallId: CallId] Value:
where
: Integer (0..65534)
CallId
The CallID is returned when the xCommand Dial command is run. During the call you
can run the xStatus Call command to see the CallId.
: Left/Right/Up/Down/ZoomIn/ZoomOut
Value
Select the action for how to move the camera.
114
API Reference Guide
xStatus
Appendices
Value
Copyright © 2017 Cisco Systems, Inc. All rights reserved.