Help; Wireless Zero Config Utility And The Summit Radio; Using The Wireless Zero Config Utility; Switching Control To Scu - Honeywell HX3 User Manual

Help

Help is available by clicking the ? icon in the title bar on most SCU screens. The SCU help may also be accessed by
selecting Start > Help and tapping the Summit Client Utility link. The SCU does not have to be accessed to view the help
information using this option.
Summit Tray Icon
The Summit tray icon provides access to the SCU and is a visual indicator of radio status
The Summit tray icon is displayed when:
• The Summit radio is installed and active
• The Windows Zero Config utility is not active
• The Tray Icon setting is On
Click the icon to launch the SCU. Use the tray icon to view the radio status:
The radio is not currently associated or authenticated to an Access Point
The signal strength for the currently associated/authenticated Access Point is less than -90 dBm
The signal strength for the currently associated/authenticated Access Point is -71 dBm to -90 dBm
The signal strength for the currently associated/authenticated Access Point is -51 dBm to -70 dBm
The signal strength for the currently associated/authenticated Access Point is greater than -50 dBm

Wireless Zero Config Utility and the Summit Radio

The WZC utility has an icon in the toolbar that looks like networked computers with a red X through them, indicating that
Wireless Zero Config application is enabled but the connection is inactive at this time (the device is not connected to a
network). The WZC icon may not be visible until control is passed to the WZC utility as described below.
You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to connect to your network. As the
Wireless Zero Configuration Utility cannot control the complete set of security features of the radio, it is recommended to
use the Summit Client Utility to connect to your network.

Using the Wireless Zero Config Utility

1. Select ThirdPartyConfig in the Active Profile drop down list as the active profile.
2. Warmboot the device. The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless
Information control panel. Using the options in the Wireless Zero Config panels, setup radio and security settings.
There may be a slight delay before the Wireless Zero Config icon indicates the status of the connection.

Switching Control to SCU

1. To switch back to SCU control, select any other profile in the SCU Active Config drop down list, except
ThirdPartyConfig.
2. Warmboot the device. Radio control is passed to the SCU.
9 - 2