Desktop Cradle Footprint; Power Cable - Honeywell HX3 User Manual

Desktop Cradle Footprint

Bottom View – Measurements are Not to Scale
Table Mounting
The cradle can be mounted to a flat, stable surface using the <1mm hole in the Tethered Ring Scanner storage bay (fasteners,
screwdrivers, etc., not supplied).
Periodically check the connection and re-tighten if necessary.

Power Cable

Important: Use the power cable provided with the cradle's power supply adapter with the desktop cradle only.
There are two types of external power supplies for the cradle:
• Power Supply, External, AC, US (with power cable)
• Power Supply, External AC, International (without power cable)
The external power supply may be connected to either a 120V, 60Hz supply or, outside North America, to a 230V, 50Hz supply,
using the appropriate detachable cord set.
In both cases, connect the external power supply 2-prong end to a source of power provided with maximum 15 Amp over cur-
rent protection (10 Amp for 230V circuits).
1. Firmly press the cradle end (L-shaped 5mm barrel connector) of the power cable into the power connector on the back of
the cradle.
2. Firmly press the C8-2 female end of the power cable into the two male connector pins on the power adapter, guided by the
connection notches on the top and bottom.
3. Plug the 2-prong end of the cable into any AC wall outlet with a dependable power source. AC power is now being supplied
to the AC/DC power adapter and the cradle.
11 - 4
Approximations
1. 5.5 in / 14 cm
2. 2.0 in / 5.1 cm
3. 2.0 in / 5.1 cm
4. 0.45 in / 1.14 cm
5. 5.5 in / 14 cm
6. 6.0 in / 15.2 cm
7. 2.5 in / 6.3 cm
Cradle Height: 3.4 in / 8.6 cm
Cradle Width: 4.75 in / 12.1 cm
Cradle w/Tethered Battery Height: 6 in / 15 cm