Installation; Assemble The Power Supply; Setup - Honeywell HX3 User Manual

Installation

Assemble the Power Supply

Note: Assemble the AC adapter for the Battery Charger before connecting it to the charger.
The AC power supply for the battery charger is shipped with the battery charger unless you require a country-specific
power supply and cable assembly.
The battery charger power supply is intended for use with the battery charger only.
1. Plug the 3-prong end of the cable into an AC wall outlet.
2. Firmly press the female end of the power cable into the male connector on the AC power adapter. An LED on the power
adapter illuminates when AC power is available.
3. AC power is now being applied to the power adapter.

Setup

Prerequisite: The AC Adapter is assembled and receiving AC power.
Place the battery charger on a flat, horizontal, hard surface or fasten securely to a stable surface using the keyhole openings on
the bottom of the battery charger.
Do not insert battery packs until the battery charger has finished powering up:
• Insert the power connector into the power outlet at the back of the battery charger.
• AC power is now being applied to the battery charger and it begins to power up.
• Charge pocket LEDs flash while the battery charger enters and exits the startup check.
• When the charge pocket LEDs are not illuminated, the battery charger is ready for use.
12 - 4