Using Opp; Pairing With An Opp Device; Remote Device Pushes File To Hx3 - Honeywell HX3 User Manual

Using OPP

Pairing with an OPP Device

Prerequisites
• A remote device, such as a mobile phone, that supports OPP.
• OPP is enabled on the HX3.
1. Place the remote device in discovery or visible mode.
2. Initiate discovery on the HX3 by tapping the Discover button on the OPP Send tab.
3. The HX3 discovers the remote device.
4. The HX3 attempts to send a file to the remote device.
5. The remote device prompts the user for a 4 digit PIN.
6. User enters the PIN.
7. The HX3 prompts the user for a 4 digit PIN.
8. User must enter the same PIN code as entered on the remote device.
9. The HX3 now pairs with the remote device.

Remote Device Pushes File to HX3

This section assumes that a device supporting OPP is paired with the HX3.
If a duplicate filename is received, LXEZ Pairing writes the file in the specified location, with an incremental number
appended to the file name. For example, if a file named file.jpg is pushed to the HX3 and that filename already exists in the
Inbox, LXEZ Pairing saves the new file as file001.jpg. If the same file is pushed again, it is saved as file002.jpg.
There are several scenarios based on configuration options on the OPP Setup tab.
Notifications enabled, HX3 is Write Capable
1. The OPP client initiates a connection to the HX3 by selecting a file to push to the HX3.
2. The HX3 user is notified that a File Push request has been issued from a remote device.
3. The HX3 user is prompted to accept or reject the incoming request.
4. If the user accepts the request:
• The file is pushed to the HX3.
• LXEZ Pairing notifies the user that a file has been received.
• The connection is closed by the remote device (OPP client).
5. If the user rejects the request:
• The file is not pushed to the HX3.
• The connection is closed.
Notifications enabled, HX3 is not Write Capable
1. The OPP client initiates a connection to the HX3 by selecting a file to push to the HX3.
2. The file is rejected silently (no notification to the HX3 user).
Notifications disabled, HX3 is Write Capable
1. The OPP client initiates a connection to the HX3 by selecting a file to push to the HX3.
2. The file is accepted silently (no notification to the HX3 user).
6 - 16