Cradle Help; Maintenance; Cleaning - Honeywell HX3 User Manual

Cradle Help

Issue:
Battery LED is Amber (Standby)
Solution:
The cradle can wait up to two hours for the battery pack temperature to return to an acceptable temperature range when the
charging process will commence. Battery packs can only be charged when their temperature is between 10°C (50°F) and 40°C
(104°F).
Issue:
Battery LED is flashing red (Fault)
Solution:
Battery pack fault or failure. Contact Customer Support (page 14-1) for help.

Maintenance

Inspect the rubber feet and replace them if missing, broken or cracked. Check the cradle regularly for excessive wear at pres-
sure points. If the cradle is mounted to a stable surface, check surface mounting connections periodically and re-tighten as nec-
essary.
If the cradle becomes cracked or broken at any time, it must be taken out of service and replaced. Contact Customer Support
(page 14-1) for a replacement cradle.
There are no serviceable parts in the desktop cradle. Do not attempt to open the unit.

Cleaning

Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the surfaces and/or battery
charging terminals (pins).
Use a clean soft cloth to wipe any dirt, moisture or grease from the HX3, spare battery packs, charging contacts (pins) or the
cradle.
Do not use any liquid to clean the battery pack, HX3, cradle, or charging pockets. Spray or dampen the cleaning cloth with liq-
uids/sprays. If possible, clean only those areas which are soiled.
Lint/particulates can be removed from the connectors, charging terminals and charging/docking pockets with clean, filtered
canned air.
11 - 10