Reboot; Warm Boot; Cold Boot; Startup Help - Honeywell HX3 User Manual

Reboot

When the HX3 desktop is displayed on the host computer or an application begins, the power up (or reboot) sequence is
complete. The HX3 must be connected to a host computer and LXEConnect must be active before proceeding to warm boot or
cold boot. Verify the HX3 has a known good power source, either a fully charged battery or docked in a powered desktop
cradle.

Warm Boot

Start > Run
A warm boot function does not affect the HX3 operating system, but data and programs in RAM are cleared, and registry
changes, if any, are saved. Network, ActiveSync and Bluetooth connections will need to be re-established.
Tap Start > Run and type WARMBOOT.EXE or WARMBOOT. This command is not case sensitive. Tap the OK button.
This process takes less than 15 seconds. Temporary data not saved is lost.
Warm boot terminates the host computer ActiveSync connection. The host computer connection must be re-established
after the HX3 boots.
There may be slight delays while the wireless client connects to the network, re-authorization for voice-enabled applications
completes, Wavelink Avalanche management of the HX3 startup completes, or Bluetooth relationships establish or re-
establish.

Cold Boot

Start > Run
The cold boot function reboots the HX3, erases all registry data and user-specified settings. The factory default settings
are restored when the HX3 powers on again.
Click Start > Run and type COLDBOOT.EXE or COLDBOOT. This command is not case-sensitive. Click the OK button.
Cold boot terminates the host computer connection. The host computer connection must be re-established after the HX3
cold boots.
Because of the extreme nature of cold boot, use this command only as an emergency or when instructed to do so as part
of a specific HX3 procedure.

Startup Help

Contact Customer Support
Issue:
HX3 seems to lockup as soon as it is rebooted.
Solution:
There may be slight delays while the wireless client connects to the network, authorization for voice-enabled applications
complete, Wavelink Avalanche management of the HX3 startup completes and Bluetooth relationships establish or re-establish.
When an application begins, the HX3 is ready for use.
Issue:
New HX3 main batteries don't last more than a few hours.
Solution:
New batteries must be fully charged prior to first use. Li-Ion batteries (like all batteries) gradually lose their capacity over time
(in a linear fashion) and never just stop working. This is important to remember – the HX3 is always 'on' even when in the
Suspend state and draws battery power at all times.
2 - 14
(page 14-1) if you need more help.