Siemens SINUMERIK 840D sl Universal Operating Manual page 311
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Figure 12-22
Procedure
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Selection list for special tools with multitool
1.
The tool list is opened.
2.
Position the cursor at the position where the tool is to be created.
For this, you can select an empty magazine location or the NC tool
storage outside the magazine.
You may also position the cursor on an existing tool in the NC tool
storage area. Data from the displayed tool will not be overwritten.
3.
Press the "New tool" softkey.
The "New Tool - Favorites" window opens.
- OR -
Press the softkey "Special tool 700-900".
4.
Select the multitool and press the "OK" softkey.
The "New Tool" window appears.
5.
Enter the multitool name and define the number of multitool loca‐
tions.
If you wish to define the clearance of the tools based on the angle,
activate the "Angle input" checkbox, and for each multitool loca‐
tion, enter the clearance to the reference location as angular value.
Tool management
12.15 Working with multitool
311
Advertisement
Table of Contents
