Siemens SINUMERIK 840D sl Universal Operating Manual page 169

Setting
Line break
Line break also in cycle
calls
Visible programs
Width per program w.
focus
Save automatically
Only cut after marking
Determine machining
times
Save machining times
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Meaning
• Yes: Long lines are broken and wrapped around.
• No: If the program includes long lines, then a horizontal scrollbar is dis‐
played. You can move the section of the screen horizontally to the end of
the line.
• Yes: If the line of a cycle call becomes too long, then it is displayed over
several lines.
• No: The cycle call is truncated.
The field is only visible if "Yes" is entered under "Line break".
• 1 - 10
Select how many programs can be displayed next to one another in the
editor.
• Auto
Specifies that the number of programs entered in a job list or up to ten
selected programs will be displayed next to each other.
Here, you enter the width of the program that has the input focus in the editor
as a percentage of the window width.
• Yes: The changes are saved automatically when you change to another
operating area.
• No: You are prompted to save when changing to another operating area.
Save or reject the changes with the "Yes" and "No" softkeys.
Note: Only for local and external drives.
• Yes: Parts of programs can only be cutout when program lines have been
selected, i.e. the "Cutout" softkey only then is active.
• No: The program line, in which the cursor is positioned, can be cut out
without having to select it.
Defines which program runtimes are determined in the simulation or in auto‐
matic mode:
• Off
Program runtimes are not determined.
• Block-by-block: The runtimes are determined for each program block.
• Non-modal: The runtimes are determined at the NC block level.
Note: You also have the option of displaying the cumulative times for
blocks.
Please observe the information provided by the machine manufacturer.
After the simulation or after executing the program, the required machining
times are displayed in the editor.
Specifies how the machining times determined are processed.
• Yes
A subdirectory with the name "GEN_DATA.WPD" is created in the directory
of the part program. There, the machining times determined are saved in
an ini file together with the name of the program. The machining times are
displayed again when the program or job list are reloaded.
• No
The machining times that have been determined are only displayed in the
editor.
Machining the workpiece
7.10 Editing a program
169