Program Control During Simulation; Changing The Feedrate - Siemens SINUMERIK 840D sl Universal Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl Universal:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Simulating machining
8.7 Program control during simulation
8.7
Program control during simulation
8.7.1
Changing the feedrate
You have the capability of changing the feedrate at any time during the simulation.
You track the changes in the status bar.
Note
If you are working with the "Simultaneous recording" function, you use the rotary switch
(override) on the control panel.
Procedure
Toggling between "Override +" and "Override -"
Selecting the maximum feedrate
228
1.
Simulation is started.
2.
Press the "Program control" softkey.
3.
Press the "Override +" or "Override -" softkey to increase or decrease the
feedrate by 5%, respectively.
- OR -
Press the "100% override" softkey to set the feedrate to 100%.
- OR -
Press the "<<" softkey to return to the main screen and perform the sim‐
ulation with changed feedrate.
Simultaneously press the <Ctrl> and <cursor down> or <cursor up> keys to
toggle between the "Override +" and "Override -" softkeys.
Press the <Ctrl> and <M> keys simultaneously to select the maximum feedrate
of 120%.
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Universal
Advertisement
Table of Contents
