Machining the workpiece
7.10 Editing a program
7.10.5
Creating a program block
In order to structure programs to achieve a higher degree of transparency, you have the option
of combining several G-code blocks to form program blocks.
Program blocks can be created in two stages. This means that you can form additional blocks
within a block (nesting).
You then have the option of opening and closing these blocks depending on your requirement.
Settings for a program block
Display
Text
Spindle
Addit. run-in code
Automat. Retraction
Procedure
Opening and closing blocks
166
Meaning
•
Block designation
•
Selecting the spindle
Defines at which spindle a program block is to be executed.
•
Yes
For the case that the block is not executed, as the specified spindle should not
be processed, then it is possible to temporarily activate a so-called "Addit. run-
in code".
•
No
•
Yes
Block start and block end are moved to the tool change point, i.e. the tool is
brought into a safe range.
•
No
1.
Select the "Program Manager" operating area.
2.
Select the storage location and create a program or open a program.
The program editor opens.
3.
Select the required program blocks that you wish to combine to form a
block.
4.
Press the "Build block" softkey.
The "Build Block" window opens.
5.
Enter a designation for the block, assign the spindle, if required, select the
additional run-in code and the automatic retraction and then press the
"OK" softkey.
6.
Press the ">>" and "View" softkeys.
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Universal