Advertisement
Symptom
Cause
Remedy
Search function activates suddenly
The skip play function is operating.
Turn off the indicator by pressing SKIP
during playback.
The SKIP PLAY indicator lights in the | PLAY.
display window.)
The repeat play function is operating.
Turn off the indicator by pressing
(The REPEAT 1, REPEAT ALL or
REPEAT or A&B.
REPEAT A'B indicator lights in the
display window.)
Search function stops.
7
There is a blank section between
Use the end search function (page 22)
selections. (The sampling frequency
when recording so that no blank is
indicator blinks on the display window.) : created.
The tape operation buttons do not
' While writing the start ID (9 seconds or
Operate after the start ID is written.
operate while writing the start ID.
18 seconds), none of the buttons
except @ and OPEN/CLOSE buttons
| Operate.
. The absolute time codes cannot be
| Recording was started from the blank
| Rewind the tape to the beginning, or
written.
section.
locate the very last point of the previous
recording, using the end search function
(page 22), and start recording from that
point.
The time search function does not
Absolute time codes are not written on | Locate a blank section using the end
operate.
the tape.
search function (page 22), and start
ce
recording from that point.
8
r
Sores
;
i 3
The amount of the designated time
Reduce the amount of the designated
$
exceeds the amount available to the
time.
Cae
beginning of the tape or the end.
H | The points of A and/or B for the
Absolute time codes are not written on | Locate a blank section using the end
repeat play cannot be set.
the tape.
search function (page 22) and start
3
recording from that point.
Point "B" is too close to point "A" .
Set point "B" again so that it is farther
away from point "A".
Point "B" is before point "A" .
: Set point "B" again so that it is located
after point "A".
End ID cannot be written during
The portion where you want to write
Set the deck in the record-pause mode
playback.
the end ID is blank.
by pressing REC, then write the end ID.
Renumbering function does not
The portion between the end of a start
| When writing the start IDs manually,
operate.
ID code and the beginning of the
write so that the intervals betweeen them|
following start ID is less than 9
are more than 9 seconds (18 secons in
Start ID cannot be erased.
seconds (18 seconds in the long-play
| the ong-play mode).
|
j
mode) long.
| Skip ID cannot be erased.
Two skip IDs are written continuously.
| When writing the skip IDs write so that
the intervals between them are more
than 1 second
(2 seconds in the lojng-
play mode).
End ID cannot be erased.
The end ID is written at the beginning
| Start recording from the beginning of the |
of the tape.
tape.
The end ID is written immediately after | Erase the start ID first.
=e
e
__}
astart ID.
"
Tape transport noise seems
| This situation depends upon the
excessively loud in rewind or fast-
cassette being used and is not a
——-
forwardmode.
a
problem.
_
@ | The tape stops running suddenly.
A defective or damaged cassette
Press the OPEN/CLOSE button to
8
has been inserted.
change the tape.
7
3 | Unbalanced left and right volume.
Incorrect adjustment of the recording
Adjusting the recording level correctly.
ae
7
level.
-
(page 20)
Increase of noise or deterioration of | Contamination of the head.
Clean the head, using the cleaning
| sound quality.
: tape.
Advertisement
