Download Print this page

Sony DTC-700 Operating Instructions Manual page 39

Digital audio tape deck
Hide thumbs Also See for DTC-700:

Advertisement

Using the Display Window Po
Each time you press COUNTER MODE, the counter changes
as follows:
7]
"TI
an
(o
=>
maa
wo
==>
iu
tts
Livi
Lts
"th
Linear counter
Absolute time
(tape running time)
ieucaaae
PGM
TIME
Aarne
4°61
Ty
i, Li Ltn LI LEs i
Wet
Elapsed time of the selection
Remaining time to the end of the whole tape
(not to the end of the recorded portion)*
Notes
At the beginning of the tape, " 3? # " may appear (and
To reset the counter to OM 00s, press RESET.
immediately go off) at the PGM NO. indicator position with
some types of pre-recorded tapes. ("3 # " stands for
*When playing back a pre-recorded tape (software),
"beginning".)
remaining time to the end.of the recorded portion appears.
To check the sampling frequencies recorded
Example:
on the tape — Frequency Map
Press 4 while keeping COUNTER MODE pressed.
Bars on the level meter light to signify the sampling
frequencies with which the material was recorded. (No bars
light until 16 seconds after playback starts.)
i
I
32 kHz!44.1 kHz!
48 kHz
32kHz
|!
Blank
32 kHz
Upper bar
44.1 kHz
| Both upper and lower bars
48 kHz
| Lower bar
"TOP", "MID" and "END" indicate the beginning, middle and
end of each tape respectively.
Elapsed time of the selection does not appear when...
Remaining time does not appear in the following cases
¢ The selection is played back from the middle.
* Immediately after the deck is set to the playback mode.
The tape is being fast-forwarded or rewound.
The remaining time will appear about 16 seconds later.
« The cassette compartment is opened or closed by OPEN/CLOSE.
* When playback is started from a blank section (page 17), the
remaining time may not appear. Press <#@ or KK.
Adjusting the headphones volume
Use the LEVEL control.
If tape noise exists, or sound quality has deteriorated
The head may be contaminated. Clean the head, using a cleaning
When the tape is played back to its end
cassette (See page 49}.
The tape will be rewound to the beginning and stop automatically.
Accuracy of the indicator for the remaining time
According to the kind of tape, the indicated time may differ slightly
from the actual remaining time.
39

Advertisement

loading