Advertisement
Writing Program Numbers
Program numbers are the codes indicating the selection order.
(See page 26 for details.)
There are two ways to write program numbers:
e Writing automatically during recording
e Renumbering automatically during playback or in the stop
mode
Writing Program Numbers Automatically During Recordingf ss
When you proceed so that the start IDs are written
automatically during recording, the program number also are
written.
Writing program numbers from the beginning
The AUTO indicator must be lit. If it is not, press START ID AUTO.
When turning on the power and inserting a cassette with its safety tab at the record-
possible position, the AUTO indicator lights.
In timer recording, the AUTO indicator will be the same as the one before the power
was turned off.
To start recording, press REC, then press PAUSE or >> (play).
The program numbers will be written in numerical order from "1" at the same
position as the start IDs.
Writing program numbers from the middle of the tape
The AUTO indicator must be lit. If it is not, press START ID AUTO.
When turning on the power and inserting a cassette with its safety tab at the record-
possible position, the AUTO indicator lights.
In timer recording, the AUTO indicator will be the same as the one before the power
was turned off.
If you are aware of the program number of the last selection, go to step 4. If
you are not aware of the program number, locate the last point of the
previous recording, using the end search function. (See page 22.)
Press [>, then press Iki.
The last selection is played, and its program number appears at the
PGM NO. indicator position.
Locate the last point of the previous recording, using the >>
button. (See page 22.)
It is important to proceed with the blank search in order not to leave a
blank section on the tape.
Press REC to set the deck in the record-pause mode.
Designate the next program number (the number that follows the
program number of the last selection) with the numeric button. Next program number
If the program number of the last selection appears at the PGM NO.
rs
indicator position, you need not designate the next number.
Press PAUSE or [> (play).
The program numbers are written consecutively, beginning from the designated
number.
if the next program number is not designated
The start IDs will be written, but the program numbers will not.
You can write the program numbers using the renumbering function
described on the next page.
31
Advertisement
