Table of Contents
Advertisement
6 PLC PROGRAM USED FOR POSITIONING CONTROL
No.9
No.10
No.11
No.12
No.14
No.13
No.14
No.15
Continued from previous page
Positioning start No.
setting program
Positioning start program
M code OFF program
JOG operation program
Inching operation program
Manual pulse generator
operation program
Continued on next page
6 - 18
Start details setting program
Refer to Section 6.5.2
Start program
Refer to Section 6.5.3
Program to reset the start
signal and turn the M code
ON signal OFF
JOG operation program
Refer to Section 11.2.4
Inching operation program
Refer to Section 11.3.4
Manual pulse generator
operation program
Refer to Section 11.4.4
MELSEC-Q
Program required to carry out
• "OPR control"
• "Major positioning control"
• "High-level positioning control"
Program required to carry out
"manual control"
Advertisement
Table of Contents
