Table of Contents
Advertisement
5 DATA USED FOR POSITIONING CONTROL
Temporarily stop for
the time set in Pr. 57
Pr.56 Speed designation during OP shift
Set the operation speed for when a value other than "0" is set for "
amount". Select the setting from "
Pr.46
0 : Designate "
Pr.47
1 : Designate "
Pr.57 Dwell time during OPR retry
When OPR retry is validated (when "1" is set for
decelerating in 2) and 4) in the following drawing.
5)
4)
Pr.46
OPR speed" or "
OPR speed" as the setting value.
Creep speed" as the setting value.
1)
6)
Start position
3)
5 - 60
MELSEC-Q
Pr.53
Pr.47
Creep speed".
Pr.48
), set the stop time after
Temporarily stop for
2)
the time set in Pr. 57
OP shift
Advertisement
Table of Contents
