Table of Contents
Advertisement
APPENDICES
Trouble type
The machine only moves to
"10081230", although positioning
with a command value of
"10081234" carried out.
How can the error be
compensated?
The following values are currently
Error compensation
set.
When carrying out a count-method
machine OPR, the message
"Leave Sufficient Distance From
The OP Position To The Near-
Point Dog OFF." appears. Is there
a problem
if the distance is short?
In the near-point dog method
machine OPR, the stop positions
are not uniform.
OPR
Can the machine OPR be carried
out with the OPR retry function
when it is started with the near-
point dog ON and the upper/lower
limit OFF?
Are ABS and INC positioning
possible without carrying out an
OPR?
After an OPR, the OPR request
flag sometimes turns ON for no
apparent reason.
Questions/Trouble
•
"
Pr.2
No. of pulses per
"
rotation
262144PLS
•
Pr.3
"
Movement amount
8000 µ m
per rotation"
Pr.3
Reset
and
1) Calculate "262144/8000 × 10081234/10081230".
2) Obtain the reduced value.
3) Set the numerator in "
rotation", and the denominator in "
per rotation".
The near-point dog must be set to turn OFF at a position
after the OP is passed.
(When the OPR is started on the near-point dog ON in a
count-method machine OPR, the machine enters a
normal machine OPR operation after returning to the
near-point dog OFF region.)
(If the near-point dog is turned OFF before the OP, and
the machine OPR is started between the near-point dog
OFF position and the OP, the machine will mistakenly
interpret that its current position is before the near-point
dog ON position, and it will pass over the OP and
continue moving.)
Carry out the following measures.
1) Separate the near-point dog signal and zero signal
detection positions.
2) Lower the values in
"
Pr.47
Creep speed
3) Confirm whether the zero signal and near-point dog
signal turn ON normally.
4) Check that there is no play (backlash) in the machine
system.
A "Hardware stroke limit error" will occur and the
operation will not be carried out.
(The machine will interpret any position where the near-
point dog is ON as being within the working range, and
that the upper/lower limit is ON.)
They are possible.
In this case, the position where the power is turned ON is
handled as the current feed value "0".
The OPR request flag turns ON in the following cases.
1) When the power is turned ON.
2) When the machine OPR has not been executed at the
absolute position system.
3) When the "absolute position lost" ( Md.108 Status: b4)
turns ON in the absolute position system.
4) When the " Pr.114 Rotation direction selection" is
changed.
5) When an OPR operation starts.
If no problem is found when the above are checked, then
it is possible that the communication is being interrupted
by "a fault in the bus cable", "noise influence", etc.
Appendix - 53
Remedy
Pr.2
in the following order.
Pr.3
Movement amount per
Pr.2
No. of pulses
"
Pr.46
"
OPR speed
"
.
MELSEC-Q
No.
18
19
and
20
21
22
23
Advertisement
Table of Contents
