Installing The Module; Electrical Installation; Necessary Tools; Wiring - ABB ACS580 Series Hardware Manual

450 Optional I/O extension and adapter modules

Installing the module

See section Installing option modules (page
￭

Electrical installation

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Stop the drive and do the steps in section
before you start the work.

Necessary tools

• Screwdriver and a set of suitable bits

Wiring

Connect the external control cables to the applicable module terminals. Ground
the outer shield of the control cables 360° under the grounding clamp on the
grounding shelf
WARNING!
Do not connect the +24 V AC cable to the control unit ground when the control
unit is powered using an external 24 V AC supply.
￭

Start-up

Setting the parameters

1. Power up the drive.
2. If no warning is shown,
• make sure that the value of both parameters 15.01 Extension module type
and 15.02 Detected extension module is CMOD-01.
If the warning A7AB Extension I/O configuration failure is shown,
• make sure that the value of parameter 15.02 is CMOD-01.
• set the parameter 15.01 value to CMOD-01.
You can now see the parameters of the extension module in parameter group
15 I/O extension module.
3. Set the parameters of the extension module to applicable values.
Examples are given below.
Parameter setting example for relay output
This example shows how make relay output RO4 of the extension module indicate
the reverse direction of rotation of the motor with a one-second delay.
164).
Electrical safety precautions (page 24)