Adjusting The Lift-Arm Turnaround Position; Folding The Rops - Toro Reelmaster 03781 Operator's Manual

Figure 40
1. Spring
4. Move the spring actuator to the desired hole location
and secure it with the locknut.
5. Repeat the procedure on the remaining spring.
Adjusting the Lift-Arm
Turnaround Position
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking
brakes, and remove the key from the ignition switch.
2. The lift-arm switch is located behind the front right
lift arm (Figure 41).
Figure 41
1. Switch
3. Loosen the switch mounting screws
move the switch up to increase the lift-arm turnaround
g015078
2. Spring actuator
g015079
(Figure 41) and
height or move the switch down to decrease the
lift-arm turnaround height.
4. Tighten the mounting screws.

Folding the ROPS

You can fold the ROPS frame down to allow access into areas
of restricted height.
WARNING
The machine does not have a rollover protection
system (ROPS) when the roll bar is folded down
and should not be considered a ROPS.
Do not wear a seatbelt when the roll bar is lowered.
1. Park the machine on a level surface, shut off the engine,
engage the parking brake, and remove the key from
the ignition switch.
2. Support the weight of the upper frame while removing
the snap pins and clevis pins from the pivot brackets
(Figure 42).
3. Carefully lower the frame downwards until it rests on
the stops.
4. Insert the clevis pins in the lower holes and secure
them with the snap pins to support the upper frame in
its lowered position.
5. To raise the frame, follow these instructions in reverse
order.
1. Upper frame
2. Clevis pins
33
Figure 42
3. Snap pins
4. Lower holes
g200378