Advertisement
12. "SYSTEM" mode
■ Network setting (2)
SYSTEM>PARAM>OP.BRD>SELECT
EDIT
Chapter
4
2) Select the parameter with the cursor ( ↑ / ↓ ) keys.
c
CAUTION
Changes you made to the IP address, subnet mask and gateway are
enabled after restarting the robot controller. When connecting the robot
controller to an existing network, always consult with the network
administrator for the IP address, subnet mask and gateway settings.
■ Network setting (3)
SYSTEM>PARAM>OP.BRD>SELECT
EDIT
3) The currently set parameters are displayed.
When changing the "Board condition" parameter, press
the Ethernet unit or press
When changing the communication mode, press
mode or press
When changing other parameters, use
press
4) Press
4-196
1.board condition
2.IP address
3.Subnet mask
4.gateway
5.port No
JUMP
1.board condition
2.IP address
3.Subnet mask
4.gateway
5.port No
JUMP
(ONLINE) to set the online mode.
.
to quit the edit mode.
V9.00
VALID
192.168.
0. 2
255.255.255. 0
192.168.
0. 1
23
V9.00
VALID
192.168.
0. 2
255.255.255. 0
192.168.
0. 1
23
(VALID) to enable the Ethernet unit.
to
and
(INVALID) to disable
(OFFLINE) to set the offline
to make the setting and
Advertisement
Chapters
