Table 9-Connecting To External Ns Beacon Receiver - NorthStar 941X Reference Manual

"
Rev. D
8800 DGPS Sensor
Pin 21 (receive)
Pin 20 (transmit)
Pin 17 (ground)
8400 beacon receiver
black (receive)
white (transmit)
orange (ground)
8401 beacon receiver
yellow (receive)
blue (transmit)
orange (ground)
Table 9—Connecting to External NS Beacon Receiver
(For connection to other sources of differential corrections, refer to the
manufacturer's instructions for wiring information.)
Now you're ready to set up the 941X to receive the data from the external
source, using the RS-232 interface port. Press the STAR key until you
display the USER CUSTOMIZATION SCREEN. Press the PORT
SETUP OPTIONS menu key. The following screen will be displayed
(information displayed by your 941X in the RS-232 SETUP box at this
time may be different):
In order to receive SC-104 corrections through the 941X's RS-232 inter-
face port, the port information box in the lower center of the screen must
read: SC-104 IN. If the port is presently set up for anything other than
SC-104 IN, press EDIT to change this setting. Use the up or down cursor
arrow keys to display SC-104 IN and press ENTER.
9 — 9 — 9 — Installation and Interfacing 9 — Installation and Interfacing Installation and Interfacing Installation and Interfacing
941X Interface Connector
red (RS-232 output) #18
green (RS-232 input) #16
tan (RS-232 ground) #17
941X Interface Connector
red (RS-232 output) #18
green (RS-232 input) #16
tan (RS-232 ground) #17
941X Interface Connector
red (RS-232 output) #18
green (RS-232 input) #16
tan (RS-232 ground) #17
Page 125