Connecting The 972 To A Remote Display; Connecting The 972 To A Video Camera - NorthStar 972 Installation Manual

Table 13: 952/951/941 to 972 wiring
952, 951, 941 Pin #
5
6
7
8
9
*Pins 1, 2, 3, 4 and 10 on the 941/951/952 aux connector, and pin 2 on the 972 aux

Connecting the 972 to a remote display

The 972's VGA connector is used to connect it with a remote display. A standard VGA cable is used.
Northstar doesn't supply the connecting cable since the cable requirements vary with each particular
installation. Check the manufacturer's instructions for further cabling and setup details.

Connecting the 972 to a video camera

The 972's BNC VIDEO connectors are used to connect to any NTSC- or PAL-compatible devices, such
as video cameras. Northstar doesn't supply the connecting cables since the cable requirements vary
with each particular installation. Check the manufacturer's instructions for further cabling and setup
details.
Video signals are not passed over the network. A separate coaxial video cable must be run to any 972
that will display video.
After you've connected the 972 to the video device, check the connection by pressing the VIDEO key
to see the video image. For instructions on moving the image and changing its size, see the Northstar
972 Reference Manual (part number GM972UM).
972 Installation Manual, Rev. B
Function
Aux In B
Ground shield
Aux Out B
Aux In A
Aux Out A
connector, aren't used.
6000i Pin # Function
5 Aux Out B
1 Ground shield
3 Aux In B
4 Aux Out A
6 Aux In A
Page 33