Smartcraft Installation; Connecting The Gateway To The Engine; Connecting The Gateway To The Northstar 6000I - NorthStar 6000I - REV A FOR VERSION 4.00 Operation And Installation Manual

SmartCraft installation

The SmartCraft system is normally installed and calibrated by
your dealer.
The Northstar SmartCraft gateway connects one or two Smart-
Craft-capable engines to a Northstar 6000i navigator. The single
gateway is for single engines; the dual gateway is for twin
engines. The Gateway must be revision 1.2.3 or higher.
WA215SRB Rev C or
WA215SRC Rev A
6000i

Connecting the Gateway to the engine

Connect cables from the engines and sensors to any ports on the
junction box. Connect the Gateway to any available port on the
junction box.

Connecting the gateway to the Northstar 6000i

Use a Northstar part no. WA215SRB, Rev C or WA215SRC, Rev A
cable to connect between the Gateway and the 6000i 's NMEA
port. This cable also interfaces the 6000i to other equipment on
GMSMCRFT Rev A
Gateway
SmartCraft connections
– 11 –
Junction
Box