ABB ACS550-02 User Manual page 51

4. Use UP or DOWN arrow key to step through to the desired group, for example "03".
5. Press MENU/ENTER.
The display shows one of the parameters in the selected parameter group. For
example, "0301".
6. Use UP or DOWN arrow key to step through to the desired parameter.
7. Press MENU/ENTER, either:
• Press and hold for about 2 seconds or
• Press the key twice in quick succession
The display shows the value of the selected parameter with
Note! Briefly pressing the MENU/ENTER key displays the parameter's current value
for about 2 seconds. During this display, pressing the MENU/ENTER key again also
enables .
SET
8. Use UP or DOWN arrow key to step to the desired parameter value.
Note! In , pressing the UP and DOWN arrow keys simultaneously displays the
SET
default parameter value.
9. In , press MENU/ENTER to save the parameter value being displayed.
SET
Note! If, instead, you press EXIT/RESET the original, or last saved, parameter value
is the active value.
10. Press EXIT/RESET to step back to the Output mode.
Par Backup Mode
The Basic Control Panel can store a full set of drive parameters. If two sets of
parameters are defined, both are copied and transferred when using this feature.
The Par Backup mode has three functions:
• uL (Upload) – Copies all parameters from the drive to the Control Panel. This
includes a second set of parameters (if defined) and internal parameters such as
those created by the Motor Id Run. The Control Panel memory is non-volatile.
• rE A (Restore All) – Restores the full parameter set(s) from the Control Panel to
the drive. Use this option to restore a drive, or to configure identical drives.
Note! The Restore All function writes all parameters to the drive, including motor
parameters. Only use this function to restore a drive, or to transfer parameters to
systems that are identical to the original system.
49
under the value.
SET
Start-Up