ABB ACS550-02 User Manual page 134

132
Group 51: Ext Comm Module
This group defines set-up variables for an external fieldbus communication module.
Refer to communication module documentation for more information on these
parameters.
Code Description
5101 FBA TYPE
Displays the type of the connected fieldbus adapter module.
0 = Module not found or not connected. Check the fieldbus User's Manual chapter "Mechanical Installation" and
check that parameter 9802 is set to 4 = EXT FBA.
1 = - –
PROFIBUS DP
16 = –
INTERBUS
21 = –
LONWORKS
32 = –
CANOPEN
37 = –
DEVICENET
64 = –
MODBUS PLUS
101 = –
CONTROLNET
128 = –
ETHERNET
5102 FB PAR 2...FB PAR 26
...
Refer to communication module documentation for more information on these parameters.
5126
5127 FBA PAR REFRESH
Validates any changed fieldbus parameter settings.
• After refreshing, the value reverts automatically to DONE.
5128 FILE CPI FW REV
Displays the CPI firmware revision of the drive's fieldbus adapter configuration file. Format is xyz where:
• x = major revision number
• y = minor revision number
• z = correction number
Example: 107 = revision 1.07
5129 FILE CONFIG ID
Displays the revision of the drive's fieldbus adapter module's configuration file identification.
• File configuration information is drive application program-dependent.
5130 FILE CONFIG REV
Contains the revision of the drive's fieldbus adapter module configuration file.
Example: 1 = revision 1
5131 FBA STATUS
Contains the status of the adapter module.
0 = – Adapter not configured.
IDLE
1 = . – Adapter is initializing.
EXEC INIT
2 = – A timeout has occurred in the communication between the adapter and the drive.
TIME OUT
3 = – Adapter configuration error.
CONFIG ERROR
• The major or minor revision code of the adapter's CPI firmware revision differs from that stated in the drive's
configuration file.
4 = - – Adapter is off-line.
OFF LINE
5 = - – Adapter is on-line.
ON LINE
6 = – Adapter is performing a hardware reset.
RESET
5132 FBA CPI FW REV
Contains the revision of the module's CPI program. Format is xyz where:
• x = major revision number
• y = minor revision number
• z = correction number
Example: 107 = revision 1.07
Start-Up