ABB ACS550-02 User Manual page 117

Group 34: Panel Display Process Variables
This group defines the content for control panel display (middle area), when the
control panel is in the control mode.
Code Description
3401 SIGNAL1 PARAM
Selects the first parameter (by number) displayed on the control panel.
• Definitions in this group define display content when the control panel is in
the control mode.
• Any Group 01 parameter number can be selected.
• Using the following parameters, the display value can be scaled, converted
to convenient units, and/or displayed as a bar graph.
• The figure identifies selections made by parameters in this group.
100 = not selected – First parameter not displayed.
101...199 = Displays parameter 0101...0199. If parameter does not exist, the display shows "n.a."
3402 SIGNAL1 MIN
Defines the minimum expected value for the first display parameter.
Use parameters 3402, 3403, 3406, and 3407, for example to convert
a Group 01 parameter, such as 0102
conveyor driven by the motor (in ft/min). For such a conversion, the
source values in the figure are the min. and max. motor speed, and
the display values are the corresponding min. and max. conveyor
speed. Use parameter 3405 to select the proper units for the display.
Note! Selecting units does not convert values.
3403 SIGNAL1 MAX
Defines the maximum expected value for the first display parameter.
3404 OUTPUT1 DSP FORM
Defines the decimal point location for the first display parameter.
• Enter the number of digits desired to the right of the decimal
point.
• See table for example using pi (3.14159).
3405 OUTPUT1 DSP UNIT
Selects the units used with the first display parameter.
• Enter positive values in parameter 3405 for a numeric display.
• Enter negative values in parameter 3405 for a bar-graph display.
0 = 8 = kh
NOT SEL
1 = A 9 = °C
2 = V 10 = lb ft
3 = Hz 11 = mA
4 = % 12 = mV
5 = s 13 = kW
6 = h 14 = W
7 = rpm 15 = kWh
122...127 = Cst
Additional bar display units
-123 =Iout -124 = Vout
3406 OUTPUT1 MIN
Sets the minimum value displayed for the first display parameter.
(in rpm) to the speed of a
SPEED
16 = °F 24 = GPM
17 = hp 25 = PSI
18 = MWh 26 = CFM
19 = m/s 27 = ft
3
20 = m /h 28 = MGD
3
21 = dm /s 29 = inHg
22 = bar 30 = FPM
23 = kPa 31 = kb/s
-125 = Fout -126 = Tout
P 0137
P 0138
P 0139
Display
Value
P 3407
P 3406
3404 Value
0
1
2
3
4
5
6
7
3
32 = kHz 40 = m /m
33 = Ohm 41 = kg/s
34 = ppm 42 = kg/m
35 = pps 43 = kg/h
36 = l/s 44 = mbar
37 = l/min 45 = Pa
38 = l/h 46 = GPS
3
39 = m /s 47 = gal/s
-127 = Vdc
115
P 3404 P 3405
P3402 P 3403
Source Value
Display Range
+ 3 -32768...+32767
(Signed)
+ 3.1
+ 3.14
+ 3.142
3 0...65535
(Unsigned)
3.1
3.14
3.142
48 = gal/m 56 = FPS
49 = gal/h 57 = ft/s
3
50 = ft /s 58 = inH O
2
3
51 = ft /m 59 = in wg
3
52 = ft /h 60 = ft wg
53 = lb/s 61 = lbsi
54 = lb/m 62 = ms
55 = lb/h 63 = Mrev
Start-Up