Remove the pedestal (frame size R8):
1. Remove the middle front cover by undoing the fixing screws.
2. Remove the lower front cover by undoing the fixing screws.
3. Lift the right support leg a little up and turn it right. Let it lock down. Turn the left leg aside in the same way. The legs will
prevent the unit from falling down during the installation.
4. Remove the OMIO board by undoing the fixing screws and disconnecting the control panel, power supply and the fibre
optic cables. Note: Mark down the connection terminals before disconnecting the cables.
5. Undo the screws that connect the busbars of the pedestal to the upper frame with a torque wrench with an extension
bar.
6. Wheel the drive frame out by using the handle.
1
2
4
3
27
3
Installation