Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual page 64

(8) Files are copied. A message for indicating to change the disk is displayed while the files are copied.
Insert the floppy disk into drive A according to the message, and then click [OK].
(9) Copying the files is continued. When the copy has finished, the finish window is displayed.
Click [Yes].
(10) Windows is shutdown.
(11) Turn off the personal computer. (In some cases, the personal computer is turned off
automatically.)
*Take out the floppy disk.
Now installing NC System Device Driver has finished. Proceed to chapter "4.3.3.2 Mounting NC
Card".
!
CAUTION
Do not turn on the personal computer until you mount NC Card according to the procedures of
chapter 4.3.3.2 "Mounting NC Card." If you turn on the personal computer without mounting
NC Card, the personal computer may not start up properly.
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.3 Setting Up NC Card and Device Driver (ISA Card)
search engine
58