Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual page 63

(6) The "Resource Settings" window is displayed.
Set the resources used by NC Card. Resource type and setup range depend on the type of the
NC Card. Setup range for each selected NC Card is set in the combo box of each resource in
advance. Select a value you want to use from the list.
The resource value available for NC Card depends on the status of the personal computer to
which the software is installed. The status of the resource in the destination personal computer
can be confirmed via the [Resource] tab page on the [Start] - [Program] - [Management Tool
(Common)] - [Windows NT Diagnostic Program] menus. Assign a resource not used by other
device currently to the NC Card.
Make a note of the selected resource type and setting, and then click [Next >].
Fill in:
(7) The "Complete Install" window is displayed.
Click [Finish].
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.3 Setting Up NC Card and Device Driver (ISA Card)
Resource type (The rotaty switch of card)
I/O port (IOPADR)
Memory (DPADR)
IRQ (IRQ)
search engine
57
Setting