Installing Nc System Device Driver (2) - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

4. Setting up MELDASMAGIC64 System
4.2 Setting Up NC Card and Device Driver (PCI Card)

4.2.2.3 Installing NC System Device Driver (2)

Installation of the device driver is continued automatically.
[Procedures]
(1) Check the connection of the NC Card, and then turn on the personal computer.
When "Add New Hardware Wizard" opens, click [Next>].
(2) Click [Next >].
(3) Uncheck all the check boxes as shown in the figure below, and then click [Next >].
(4) Click [Next >].
27
Downloaded from ManualsNet.com search engine