Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual page 43

(11) Files are copied. A message prompting a disk change is displayed while the files are copied.
Insert the floppy disk into drive A according to the message, and then click [OK].
(12) Copying the files is continued. When copying the files has finished, the finish window is displayed.
Click [Finish].
(13) The "System Settings Change" window is displayed.
Click [Yes].
(14) Windows is shutdown, and you can turn off the computer.
(15) Turn off the personal computer. (In some cases, the personal computer is turned off
automatically.)
*Take out the floppy disk.
Now the installation of NC System Device Driver has been completed. Proceed to chapter
"4.3.1.2 Mounting NC Card."
!
CAUTION
Do not turn on the personal computer until you mount NC Card according to the procedures of
chapter 4.3.1.2 "Mounting NC Card." If you turn on the personal computer without mounting
NC Card, the personal computer may not start up properly.
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.3 Setting Up NC Card and Device Driver (ISA Card)
search engine
37