Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual page 18

4. Setting up MELDASMAGIC64 System
4.2 Setting Up NC Card and Device Driver (PCI Card)
(4) Install the software according to the directions of the installation program.
With the default screen displayed, select [Next >], and then click [Finish] at the end.
(5) The following message is displayed. Click [Continue Anyway].
*The screen does not exist for
Windows2000.
(6) If the "Insert Disk" window is displayed, insert the next disk into drive A, and then click [OK].
12
Downloaded from ManualsNet.com search engine