Installing Nc System Device Driver For Windows Nt; Installing Nc System Device Driver - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

Table of Contents

4.3.3 Installing NC System Device Driver for Windows NT

Install NC System Device Driver according to the procedures below.

Install Device Driver by executing setup.exe on the NC System Disk 1 floppy disk.

(Hardware is not detected automatically.)

When you install NC System Device Driver, be sure to log in Windows NT as Administrator.

[Procedures]

(1) Insert the floppy disk titled "NC System Disk 1" into drive A.

(2) Click [Run...] on the [Start] menu of the task bar.

(3) Fill in the [Open:] field as below, and then click [OK].

a:\setup.exe

(4) The "Welcome" window is displayed.

Click [Next >].

(5) The "Select Device" window is displayed.

Select "Mitsubishi PC-Based NC MELDASMAGIC64 (HR62xx)," and then click [Next >]. (Specify

the xx of HR62xx according to the NC Card you use.)

Downloaded from

ManualsNet.com

4. Setting up MELDASMAGIC64 System

4.3 Setting Up NC Card and Device Driver (ISA Card)

search engine

Table of Contents

Cnc meldasmagic64