GE AF-650 GP Programming Manual page 126

DN-14 Net Reference
Read only from Keypad
Option:
[0] * Off
[1] On
DN-15 Net Control
Read only from Keypad
Option:
[0] * Off
[1] On
3.11.3 DN-2# COS Filters
Parameters to configure the filtering of Change of State data.
DN-20 COS Filter 1
Range:
0* [0 - FFFFF]
DN-21 COS Filter 2
Range:
0* [0 - FFFFF]
DN-22 COS Filter 3
Range:
0* [0 - FFFFF]
DN-23 COS Filter 4
Range:
0* [0 - FFFFF]
3.11.4 DN-3# Parameter Access
Parameters to configure the acces to indexed parameters and defining programming set-up.
DN-30 Array Index
Range:
0* [0 - 255]
Function:
Select the reference source in Instance 21/71 and 20/70.
Enables reference via analog/digital inputs.
Enables reference via the network.
Function:
Select the control source in Instance 21/71 and 20-70.
Enables control via analog/digital inputs.
Enable control via the network.
Function:
Enter the value for COS Filter 1 to set up the filter mask for the Status Word. When operating in COS
(Change-Of-State), this function filters out bits in the Status Word that should not be sent if they change.
Function:
Enter the value for COS Filter 2, to set up the filter mask for the Main Actual Value. When operating in COS
(Change-Of-State), this function filters out bits in the Main Actual Value that should not be sent if they
change.
Function:
Enter the value for COS Filter 3, to set up the filter mask for PCD 3. When operating in COS (Change-Of-
State), this function filters out bits in PCD 3 that should not be sent if they change.
Function:
Enter the value for COS Filter 4 to set up the filter mask for PCD 4. When operating in COS (Change-Of-
State), this function filters out bits in PCD 4 that should not be sent if they change.
Function:
View array parameters. This parameter is valid only when a DeviceNet fieldbus is installed.
AF-650 GP Programming Guide
3
125