GE AF-650 GP Programming Manual page 125

3.11.2 DN-1# DeviceNet
Parameters to configure the Process Data Type, Config Write, Config Read, Warnings, and keypad control of DeviceNet.
DN-10 Process Data Type Selection
Option:
3
[0] * INSTANCE 100/150
[1] INSTANCE 101/151
[2] INSTANCE 20/70
[3] INSTANCE 21/71
DN-11 Process Data Config Write
Select the process write data for I/O Assembly Instances 101/151. Elements [2] and [3] of this array can be selected. Elements [0] and [1] of the array are fixed.
Option:
Select the process write data for I/O Assembly Instances 101/151. Elements [2] and [3] of this array can be selected. Elements [0] and [1] of the array are fixed.
DN-12 Process Data Config Read
Select the process read data for I/O Assembly Instances 101/151. Elements [2] and [3] of this array can be selected. Elements [0] and [1] of the array are fixed.
Option:
DN-13 Warning Parameter
Range:
0* [0 - FFFFF]
124
Function:
Select the Instance (message) for data transmission. The Instances available are dependent upon the
setting of par. O-10 Control Word Profile.
When par. O-10 Control Word Profile is set to [0] Drive protocol, par. DN-10 Process Data Type Selection
options [0] and [1] are available.
When par. O-10 Control Word Profile is set to [5] ODVA, par. DN-10 Process Data Type Selection options
[2] and [3] are available.
Instances 100/150 and 101/151 are GE-specific. Instances 20/70 and 21/71 are ODVA-specific AC Drive
profiles.
For guidelines in message selection, please refer to the DeviceNet Operating Instructions.
Note that a change to this parameter will be executed immediately.
Function:
Function:
Function:
View a DeviceNet-specific Warning word. One bit is assigned to every warning. Please refer to the Devi-
ceNet Operating Instructions for further information.
Bit: Meaning:
0 not active
1 Explicit connection timeout
2 I/O connection
3 Retry limit reached
4 Actual is not updated
5 CAN bus off
6 I/O send error
7 Initialization error
8 No bus supply
9 Bus off
10 Error passive
11 Error warning
12 Duplicate MAC ID Error
13 RX queue overrun
14 TX queue overrun
15 CAN overrun
AF-650 GP Programming Guide