GE AF-650 GP Programming Manual page 119

3.10.3 O-3# Drive Port Settings
Parameters to configure the GE drive port.
O-30 Protocol
Option:
[0] * Drive
3
[1] Drive MC
[2] Modbus RTU
O-31 Address
Range:
1.* [1. - 126.]
O-32 Drive Port Baud Rate
Option:
[0] 2400 Baud
[1] 4800 Baud
[2] * 9600 Baud
[3] 19200 Baud
[4] 38400 Baud
[5] 57600 Baud
[6] 76800 Baud
[7] 115200 Baud
O-33 Drive Port Parity
Option:
[0] * Even Parity, 1 Stop Bit
[1] Odd Parity, 1 Stop Bit
[2] No Parity, 1 Stop Bit
[3] No Parity, 2 Stop Bits
O-35 Minimum Response Delay
Range:
10 ms* [1 - 10000. ms]
O-36 Max Response Delay
Range:
10001. ms* [11. - 10001 ms]
O-37 Max Inter-Char Delay
Range:
25.00 ms* [0.00 - 35.00 ms]
118
Function:
Select the protocol for the drive (standard) port.
Function:
Enter the address for the Drive (standard) port.
Valid range: 1 - 126.
Function:
Baud rate selection for the Drive (standard) port.
Function:
Parity and Stop Bits for the protocol par. O-30 Protocol using the Drive Port. For some of the protocols,
not all options will be visible. Default depends on the protocol selected.
Function:
Specify the minimum delay time between receiving a request and transmitting a response. This is used
for overcoming modem turnaround delays.
Function:
Specify the maximum permissible delay time between transmitting a request and receiving a response.
Exceeding this delay time will cause control word time-out.
Function:
Specify the maximum permissible time interval between receipt of two bytes. This parameter activates
time-out if transmission is interrupted.
This parameter is active only when par. O-30 Protocol is set to Drive MC [1] protocol.
AF-650 GP Programming Guide