A0503 Dc Bus Charging Active; A0510 Test Run For Voltage Control; A0511 Test Run For Current Control - Bosch Rexroth IndraDrive Troubleshooting Manual

Rexroth IndraDrive

A0503 DC bus charging active

A0510 Test run for voltage control

A0511 Test run for current control

DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Supported by Supply Unit:
The DC bus is presently charged to the crest value of the mains voltage
("soft start"). When the voltage in the DC bus has reached the crest value
of the mains voltage, the mains contactor is switched in.
A0503 - Attributes
Display: charg
Mess. no.: A0503 (hex)
Supported by Supply Unit:
The mains contactor has been switched in, the DC bus is regulated to
65 V. All monitoring thresholds have been adjusted for a test run at 43 V
mains voltage.
Note: This operating status is only available for manufacturer-side
testing and developing purposes!
A0510 - Attributes
Display: lb
Mess. no.: A0510 (hex)
Supported by Supply Unit:
The mains contactor has been switched in, the DC bus current is
regulated with regard to a preset command value. All monitoring
thresholds have been adjusted for a test run at 43 V mains voltage.
Note: This operating status is only available for manufacturer-side
testing and developing purposes!
A0511 - Attributes
Display: i lb
Mess. no.: A0511 (hex)
Status Diagnostic Messages
HMV01
HMV01
HMV01
6-35